From:	Jeff Clark
Sent:	Thursday, April 07, 2005 1:17 PM
To:	Andrew Ritchie (E-mail); Andy Broff (E-mail); Bill Larch (E-mail); Bob Campbell (E-mail); Brad Carter (E-mail); Cathy Devlin (E-mail); Greg Shank (E-mail); Jeff Clark (E-mail); Jim Gutzwiller (E-mail); Jim Matasic (E-mail); Jim Moritz (E-mail); Jim Rutherford (E-mail); Jim Wells (E-mail); John Haegelin (E-mail); Jose Gutierrez (E-mail); Keith Selby (E-mail); Ken Goshorn (E-mail); Mark Cooper (E-mail); Michael Minotti (E-mail); Pat Fetterman (E-mail); Riccardo Conti (E-mail); Ron Buck (E-mail); Scott Richards (E-mail); Steve Kennedy (E-mail); Tom Franklin (E-mail); Wim Van Dam (E-mail)
Subject:	T-12 Minutes of April 7 2005
Attendance - Jim Moritz, John Haegelin, Jim Matasic, Bob Campbell, Cathy Devlin, Scott Richards, Andy Broff, Riccardo Conti, Greg Shank, Ken Goshorn, Ron Buck, Jeff Clark, Jim Rutherford, Jim Gutzwiller

Membership - no changes.

Minutes - of 3/29/05 approved as issued.

Lab Readiness
The lab summary document was reviewed and the labs agreed to their action items. It was noted that the procedure is lacking in specifying the exhaust barrel configuration. Jeff will update that and the labs will confirm conformance. The panel agreed to allow Afton to keep the ecm fuel temp sensor dummied out with a resistor provided that it reads out to 104 deg F. The panel also addressed the procedure issues resulting from the lab visits and these will be contained in the next update. At the conclusion of the discussion, a motion that all five labs are matrix ready passed unanimously.

Parts - Ron indicated that they have been shipped to TEI, but TEI has not yet received them. Turnaround upon receipt will be around three days for the first set of hardware.

Oil - Oil 820-2 and PC-10E are ready, PC-10B will be mixed at the TMC prior to shipment. This should be done by the end of the week. It should be ready to ship sometime next week. However, oils cannot be shipped until the details of the matrix design are completed.

Matrix Start - assuming MOA, parts and oil available by the week of 4/18, the labs gave the following estimates for matrix start:
SR - week of 4/25
PE - week of 5/2
Afton - week of 5/2
XOM - week of 5/2
LZ - week of 5/2

Next Conference Call - tbd just prior to matrix start.

Regards,

Jeff Clark
Staff Engineer
ASTM Test Monitoring Center
6555 Penn Avenue
Pittsburgh, PA 15206
412-365-1032
412-848-8843 (cell)
jac@astmtmc.cmu.edu